Description
Details
Magazine Release
The Zev Technologies Generation 4 and 5 Magazine release for the Glock® is constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black. It has a Honeycomb non-slip face for a more tactile engagement surface. The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes. The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver. NOTE: It is easiest to remove and replace the factory Glock® Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and replace it with the ZEV component. ZEV Parts always incorporate design, feel and performance.
Description:
- Glock Gen 4-5 Small Frame
- Aluminum
- Honeycomb non-slip face for a more tactile engagement surface
- The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes
- Note: it is easiest to remove and replace the GLOCK Mag Catch Spring for the magazine release installation
Compatibility
- Glock 17 (4th Gen)
- Glock 17 (5th Gen)
- Glock 19 (4th Gen)
- Glock 19 (5th Gen)
- Glock 19X
- Glock 22 (4th Gen)
- Glock 22 (5th Gen)
- Glock 23 (4th Gen)
- Glock 23 (5th Gen)
- Glock 26 (4th Gen)
- Glock 26 (5th Gen)
- Glock 27 (4th Gen)
- Glock 27 (5th Gen)
- Glock 31 (4th Gen)
- Glock 32 (4th Gen)
- Glock 33 (4th Gen)
- Glock 34 (4th Gen)
- Glock 34 (5th Gen)
- Glock 35 (4th Gen)
- Glock 37 (4th Gen)
- Glock 45
